Garage Door Bottom Seals Replacement

Garage door bottom seals play a crucial role in ensuring the proper operation and energy efficiency of your garage door. Worn-out or damaged seals can lead to a variety of problems, including drafts, water infiltration, and increased energy consumption. Replacing garage door bottom seals is a relatively simple and inexpensive task that can be completed in just a few hours.

To determine if your garage door bottom seal needs to be replaced, look for signs of wear or damage, such as cracks, tears, or gaps. You can also check the seal by closing the garage door and looking for any light that shines through from the outside. If you see any light, it means that the seal is not tight enough and needs to be replaced.

To replace a garage door bottom seal, you will need a new seal, a screwdriver, and a utility knife. First, remove the old seal by carefully prying it off with the screwdriver. Be careful not to damage the garage door or the surrounding area.

Once the old seal is removed, clean the surface of the garage door where the new seal will be installed. This will help to ensure a good bond between the seal and the door. Next, apply a thin bead of sealant to the bottom of the garage door, where the new seal will be installed.

Now, position the new seal over the sealant and press it firmly into place. Use the screwdriver to drive screws into the pre-drilled holes in the seal. Be sure to space the screws evenly along the length of the seal.

Once the seal is installed, test it by closing the garage door and looking for any light that shines through. If you see any light, adjust the seal until it is tight enough to prevent any air or water from entering the garage.

Replacing a garage door bottom seal is a simple task that can make a big difference in the performance of your garage door. By following these steps, you can ensure that your garage door is properly sealed and operating at its best.