Liftmaster Garage Door Opener Remote Programming

Programming a Liftmaster garage door opener remote is a simple process that can be completed in a few minutes. By following these instructions, you can easily program your remote to open and close your garage door.

Materials Needed

* Liftmaster garage door opener * Liftmaster garage door opener remote * Ladder (optional)

Instructions

1. Locate the Learn button on the garage door opener. The Learn button is usually located on the back or side of the opener, and it is typically red or orange. 2. Press and hold the Learn button for 2 seconds. The LED light on the opener will start to flash. 3. Within 30 seconds, press and hold the desired button on the remote for 2 seconds. The LED light on the opener will stop flashing when the remote is programmed. 4. Test the remote to make sure it is working properly. Press the button on the remote to open and close the garage door.

Troubleshooting

* If the remote does not program, try the following: * Make sure that the batteries in the remote are fresh. * Make sure that the Learn button on the opener is pressed and held for 2 seconds. * Make sure that the desired button on the remote is pressed and held for 2 seconds. * If the remote still does not program, you may need to reset the opener. To reset the opener, follow these steps: * Unplug the opener from the power outlet. * Wait 30 seconds. * Plug the opener back into the power outlet. * Press and hold the Learn button on the opener for 10 seconds. * The LED light on the opener will start to flash. * Within 30 seconds, press and hold the desired button on the remote for 2 seconds. * The LED light on the opener will stop flashing when the remote is programmed.

Tips

* You can program up to 16 remotes to a single garage door opener. * If you lose a remote, you can easily program a new one by following the instructions above. * If you have any problems programming your remote, you can contact Liftmaster customer service for assistance.