How To Reprogram A Genie Garage Door Remote

Step 1: Preparation Before you start the reprogramming process, make sure you have the following items nearby: - Genie garage door remote - Genie garage door opener - A ladder (optional) - A screwdriver (optional) Step 2: Locate the Learn Button - The Learn button is typically located on the back or side of the garage door opener motor unit. It is usually a small, black button with the word "Learn" or a light next to it. Step 3: Clear the Remote's Memory - Press and hold the remote's two outer buttons simultaneously (usually the up and down buttons) for 10-15 seconds. The remote's LED light will flash rapidly to indicate that the memory has been cleared. Step 4: Put the Opener into Learn Mode - Press and release the Learn button on the garage door opener motor unit. The light next to the button will flash to indicate that the opener is in learn mode. Step 5: Program the Remote - Within 30 seconds of putting the opener into learn mode, press and hold the desired button on the remote control that you want to use to open the garage door. - Hold the button for 5-10 seconds until the LED light on the remote stops blinking and stays solid. - Repeat this step for any additional remote controls that you want to program. Step 6: Test the Remote - Once you have programmed all of the desired remotes, press the button on one of the remotes to test if it works. The garage door should open and close properly. Step 7: Troubleshooting - If the remote does not work after following these steps, try the following troubleshooting tips: - Check that the batteries in the remote are fresh and properly installed. - Make sure that the antenna wire on the garage door opener motor unit is securely connected. - If you are using an older Genie garage door opener, you may need to reprogram the remote using the two-button method. This involves pressing and holding the two inner buttons on the remote simultaneously (usually the up and down buttons) for 10-15 seconds. - If you are still having trouble programming the remote, contact Genie Customer Support for assistance.