How To Reprogram A Genie Garage Door Opener

If you've recently purchased a new Genie garage door opener, or if you've lost the remote control for your existing opener, you'll need to reprogram it. The process is relatively simple and can be completed in a few minutes.

Here's a step-by-step guide on how to reprogram a Genie garage door opener:

Gather your materials. You will need a ladder, a Phillips head screwdriver, and the new remote control or keypad.
Locate the control panel. The control panel is usually located on the back or side of the garage door opener motor unit.
Open the control panel. Use the Phillips head screwdriver to remove the screws that hold the control panel in place.
Find the learn button. The learn button is usually a small, red button located on the control panel.
Press and hold the learn button. The LED light on the control panel will begin to flash.
Press the button on the new remote control or keypad. The LED light on the control panel will stop flashing when the new remote control or keypad has been programmed.
Repeat steps 5 and 6 for any additional remote controls or keypads that you want to program.
Close the control panel. Replace the screws that hold the control panel in place.
Test the new remote control or keypad. Press the button on the new remote control or keypad to open and close the garage door.