How Do I Change My Garage Door Opener Code

How Do I Change My Garage Door Opener Code?

Changing the code on your garage door opener is a relatively simple task that can be completed in just a few minutes. By following these simple steps, you can ensure that your garage remains secure from unauthorized entry.

Step 1: Locate the Learn Button

The first step is to locate the "learn" button on your garage door opener. This button is typically located on the back of the motor unit and is usually covered by a small, plastic cover. Once you have found the "learn" button, remove the cover.

Step 2: Hold Down the Learn Button

With the cover removed, press and hold down the "learn" button. The LED light on the opener should begin to flash.

Step 3: Press the Remote Button

While holding down the "learn" button, press and hold down the button on the remote control that you want to program. The LED light will stop flashing and remain lit.

Step 4: Release the Buttons

Release the "learn" button on the garage door opener and the button on the remote control. The LED light should turn off.

Step 5: Test the Remote Control

Test the remote control by pressing the button. The garage door should open and close.

Step 6: Repeat for Additional Remotes

If you have additional remotes that you want to program, repeat steps 2-4 for each remote.

Tips

Here are a few tips for changing your garage door opener code:

Make sure that the remote control is close to the garage door opener when you are programming it.
If the LED light does not flash when you press the "learn" button, check to make sure that the batteries in the remote control are fresh.
If you are still having trouble programming the remote control, consult the owner's manual for your garage door opener.