Garage Door Cable For Torsion Springs
Garage door cables are an essential component of any torsion spring system. They work in conjunction with the springs to lift and lower the door smoothly and safely. When one or both of the cables snap, the door can become unbalanced and difficult to operate.
There are two main types of garage door cables: wind-up cables and torsion cables. Wind-up cables are attached to the bottom of the door and wrap around a drum that is connected to the torsion spring. As the door is lifted, the cables wind up on the drum, which in turn tightens the spring. Torsion cables are attached to the sides of the door and are connected to the torsion spring at the top of the door. As the door is lifted, the cables twist, which in turn tightens the spring.
Garage door cables are typically made of galvanized steel. They are available in a variety of diameters and lengths to accommodate different door sizes and spring strengths. It is important to use the correct size and type of cable for your particular garage door.
Garage door cables can last for many years, but they can eventually wear out or break. If you notice that your garage door is becoming difficult to operate, it is important to inspect the cables for any damage. If the cables are frayed, rusted, or broken, they should be replaced immediately.
Replacing garage door cables is a relatively simple task that can be completed in a few hours. However, it is important to take safety precautions when working on your garage door. Always disconnect the power to the door before starting any work.
To replace the garage door cables, you will need the following tools:
- A ladder
- A pair of pliers
- A screwdriver
- A new set of garage door cables
Once you have gathered your tools, follow these steps to replace the garage door cables:
1.Disconnect the power to the garage door
. 2.Raise the garage door until it is about halfway open
. 3.Locate the cables that are attached to the bottom of the door. There will be two cables on each side of the door
. 4.Using the pliers, remove the cotter pins that are holding the cables in place
. 5.Detach the cables from the bottom of the door
. 6.Locate the cables that are attached to the torsion spring. There will be two cables on each side of the spring
. 7.Using the pliers, remove the cotter pins that are holding the cables in place
. 8.Detach the cables from the torsion spring
. 9.Feed the new cables through the holes in the bottom of the door
. 10.Attach the cables to the torsion spring
. 11.Insert the cotter pins through the holes in the cables to secure them
. 12.Repeat steps 9-11 for the other side of the door
. 13.Lower the garage door all the way down
. 14.Reconnect the power to the garage door
.Your garage door should now be working properly. If you have any questions or concerns, please consult with a qualified garage door technician.
Cables For Torsion Spring Garage Doors
Garage Door Torsion Spring Cables For 7ft High Pair
Garage Cable 3 32 Torsion Spring 7ft
Garage Door Cable And Fittings
Garage Door Cables For Torsion Spring Doors 7 8 9 10 11 12 14 High Ebay
1 8 7 X Torsion Cable Assembly Fits Ft High Doors
Torsion Spring Cable Set Replacement For 7ft High Garage Door
Garage Door Springs 5 Faq S Allgood Company
Garage Door Torsion Spring Adjustable Cables 17 5ft Pair
Garage Door Cables Types Malfunctions Essential Upkeep A Better
